Ipmi reboot command 5 LAN Interface lanplus IPMI v2. Make sure that the server is set to start during startup and start the IPMI service. Immediately turn off power for the IPU and IPU-Gateway domains, without saving state $ ipmitool-I lanplus-C 3-p 623-U <bmcuser>-P <bmcpass>-H <bmcip> power off under Debian 5: modprobe ipmi_devintf; modprobe ipmi_si; The approach described below has been tested on an Intel SR2500 under CentOS 4 using ipmitool version 1. Unable to open SDR for reading. WARM RESET. This command worked to reset the ADMIN account's password: ipmitool -I open user set password 2 ADMIN Request the system to boot from an alternate boot device on next reboot. Perform remote chassis power This command may be used to execute raw I2C commands with the Master Write-Read IPMI command. . Man and help info for IPMItool. If you can't connect to the BMC via web, ssh, IPMI, telnet, or other connection mechanism that you have configured, then the only way to reset the BMC for sure is to power In the event the IPMI needs to be rebooted, this can be done via a Linux host using the tool "ipmitool" If you have local access to the host OS, you can run the following The following section contains a list of all commands defined in the IPMI v2. zhavckqiohptpribpoxuimkpkmhzwcebkscwrrevgbfrissfpoalrbowdmzshowgzfimfoajkhdtllg